Recent content by ikcarus

Yes, I haven't had that problem either before. Hence I'm thinking through all possible scenarios. It occurs at random times, which doesn't help troubleshooting!

HI all, Hikvision KD-8 access control. Using both relays. Relay two is set for volt free operation. Seemingly, it's randomly closing at times. I'm trying to think of ideas as to why this is happening - the software logs show no action. Could it be a floating earth changing the reference...

Had a play with this tonight. Here are my findings: Under the new firmware - yes, remain open is an option. But it seems, only via the web interface. I can't see a way to map a keypad input to remain open (unless I'm reading it wrong). An idea I have had for a simple implantation is a...

Can you elaborate?

I’ll explore whether a trigger (keypad, tag) can be mapped to remain open on lock 1. And same then to open on lock 2

It sounds like the new firmware is the solution! Remain open should fulfill what I need. I’ll upgrade and test

I want to use an IP Intercom (KD8) for a set of electric gates. My intention is to use the dual lock function to provide two different opening regimes for the gate: - Lock 1 - open the gate and allow the motors auto close function to close the gate after a period of time. (Straight forward) -...

Doing some more research into this - a HDMI to IP encoder seems to be the best way to do this!

I've been searching the forums for an answer, but can't seem to find something just aligned with this problem. I am installing a Hik NVR into remote site, which will have a fibre router installed. (Site A). I will have a VPN to that router from (Site B) and would like to be able to monitor the...

Update - have tried configuring the terminals both manually and via ivms. Reset to defaults etc... Multimeter confirms electrical connection between RS485+/RS485-. Would anybody have any suggestions as to why these terminals are not communicating with each other, or do I need to turn another...

I've installed two Min-Moe terminals to control a single mag lock. I'm using RS485 between them with one configured as card reader, one as access controller. I can't get the module which is acting as a card reader to open the door via the access controller. I've checked the Rs485 wiring (blue...

I have bell wire coming to an old doorbell. In an ideal world, I'd like to use that and not have to try and fish CAT6 (or anything) back through the property! Corner plate - I think some 3D printing might be needed, it's certainly something needed with these units

Similarly, is there a 45 degree mounting plate for corner mounting?

Bumping this - there must be a connector out there to fit the terminals, for use without the RJ45plug?

Consulting the collective experience of the group - what is, in your eyes the most secure way to stream to the web. I know I could setup an axis camera and run something like the cam streamer application, but the site is already littered with HikVision cameras, it makes more sense to try with...