Search results

Can anyone help me with this please? I just need to understand if a wifi camera can be connected to an existing IP NVR and what features the camera should support to enable this? Thanks in Advance

I am looking for a bit of help with adding another camera to my existing system. I have an Ony-x Falcon FALC-NVR-8BB NVR and 3 bullet and 2 turret 5Mp Qvis cameras. They are all still working fine, however I need to add another camera and I can't get an ethernet cable or coax to its proposed...

Many thanks Dan thats really helpful, One final point. The height of the camera seems to have quite a large bearing on the three zones Confirmed, Recognised and Detected. e.g if you have the camera quite low down at say 2.5m with an angle of less than 10 degrees the zones are very narrow...

Thanks Dan, I have used a Hikvision 4K camera but not really sure what I am looking at and how to analyse the results ie what does Confirmed, Recognised and Detected relate to? Fozzie

We are looking to live stream video to YouTube from a CCTV camera in our Village Hall using RTMP protocol. this is so village residents can view Parish Council and other meetings held in the hall during Covid-19 and possibly later to reach a wider audience. The main hall is approximately 15m...

Hi, Can someone advise if any of the Dahua Bullet cameras will stream direct to YouTube using the RMTP protocol. I have seen reviews on YouTube of the DH-IPC-HDW5831R-ZE which according to the review,with a later firmware installed, is able to stream direct yo YouTube without an intermediate PC...

Thanks but as I already have a camera I just wanted to extend the use of that. I think perhaps a cheap CB radio speaker (£6.99 from eBay) and a basic microphone with long lead might work.(Might need a little mono amp to power the speaker though). There is an audio in (Mic) and audio out...

I have a Qvis 5Mp POE IP camera (EYEVIP-5-FW) covering my front door connected to a Onyx Falcon FALC-NVR-8 OYN-X 8ch 5MP NVR. I would like to install two way audio to it so I can hear and speak to delivery drivers via an app on my phone. What is the best way to achieve this? Should I try and...

How are you powering the camera? Are you putting 12v DC on two of the cores of the cat5? If so that is likely you issue. the voltage drop on the 24/26 swg cat 5 cores will be too much. POE runs up to 48V normally not 12v. Also your Swann system uses coaxial cable for video. I don't think you can...

Just a thought but what bandwidth Powerline adapters are you using> There are now sets that run at up to 2000Mbps https://www.amazon.co.uk/TL-PA9020KIT-Powerline-Transfer-Streaming-Configuration/dp/B06XKKRDVR/ref=sr_1_12?keywords=homeplugs&qid=1574202957&sr=8-12 This is obviously theoretical...

The obvious answer to your question would be steel conduit. The conduit used in plastered walls is generally plastic although you can get steel u section but it would need to be screwed to the wall in several places. Where are you from? If the UK we use 20mm 25mm 32mm etc screwed conduit and...

Many thanks Phil, Once I receive the cameras I will try what you suggest however at first look it appears to be a browser plug in rather than a standalone APP. Kind regards Fozzie

I have just purchased an Onyx/Qvis Falcon FALC-NVR-8 NVR made by AData. I would like to view either the NVR or the cameras themselves on a Windows 10 computer. I beliveI can use a web browser and access the interface of the NVR but if available would rather use an App that can view and select...